A sticking door fix is one of the most common jobs in any home, and it is often quicker and cheaper than you expect. A door that rubs, jams or will not latch is annoying, and it can damage the frame and paintwork over time. The good news is that most causes are simple to find. This guide shows you why doors stick, how to fix them step by step and when it is time to call a professional joiner.
Why Do Doors Stick?
Doors stick for many reasons. Finding the cause first stops you wasting time on the wrong repair.
Humidity and Swelling
Timber absorbs moisture and swells when the air is damp. Doors often stick in wet weather and ease off in dry spells. Bathrooms, kitchens and rooms with poor ventilation are common problem areas. If swelling continues all year, look for leaks or damp walls.
House Movement and Settlement
Homes shift slightly over time. Frames can twist out of square, which closes the gap between door and frame. London has many older properties that settle and move with the seasons, so this is common here.
Loose or Worn Hinges
Hinges carry the whole weight of the door. Screws loosen with daily use, and the door begins to drop and rub. Worn hinge pins and damaged screw holes make the problem worse.
Layers of Paint
Repeated repainting builds up thick layers on the door edge and frame. Even a thin extra layer can make a tight door catch. Paint on hinges, latches and strike plates also causes jamming.
Warped Door or Frame
Timber can bend if it dries unevenly or if only one side is sealed. A warped door leaves a gap in one area and jams in another. Severe warping often needs professional repair or replacement.
Where Is the Door Sticking? A Quick Diagnosis
Watch how the door moves. Open and close it slowly and look for shiny or scuffed marks on the edge or frame. These mark the exact rub point. Slide a thin piece of card around the gap. Wherever the card jams, the gap is too tight.
Check the gap all the way round. It should look even on the top and latch side. If the gap is wide at one end and tight at the other, the door has likely dropped or the frame has moved. Knowing where the problem sits tells you which fix to try first.
Door Sticking at the Top: Causes and Fixes
A door sticking at the top usually points to a dropped door. The top hinge screws may have loosened, which pulls the door down at the latch side. The frame can also lean slightly, closing the gap above the door.
Start by tightening every hinge screw, especially on the top hinge. If a screw spins without gripping, the hole is worn. Replace it with a longer screw that bites into the solid timber behind the frame. If the door still rubs, a thin cardboard shim behind the bottom hinge can lift the top corner slightly. Only plane the top edge if these steps fail.
Door Not Closing Properly: What to Check
If your door is not closing properly, the latch may not meet the strike plate. A dropped door makes the latch sit too low, so it hits the frame instead of the opening. Paint build-up on the latch or plate can also stop it from clicking shut.
First, check the hinges and tighten them. Then close the door gently and see where the latch lands. If it is slightly off, file the strike plate opening until the latch slides in smoothly, or move the plate. Clean any paint off the latch and add a little lubricant. If the door is warped or the frame is out of square, the fix is more involved and a joiner may be the best choice.
Tools and Materials You Need
Most fixes need only basic tools. Gather these before you start:
- A screwdriver or drill and a selection of screws, including longer ones
- A pencil and a thin piece of card to mark and test gaps
- Sandpaper in medium and fine grades, plus a sanding block
- A sharp hand plane, for small amounts of timber removal
- A small file for adjusting the strike plate
- Cardboard shims for hinge adjustment
- Primer, paint or sealant for bare timber edges
- Dust sheets, a dust mask and safety glasses
Sticking Door Fix: Step by Step
For a reliable sticking door fix, start with the simplest repair and work up. Many doors only need the first or second step.
Start by finding the rub marks. Close the door slowly and mark the shiny or scuffed areas with a pencil. Then tighten all hinge screws. Replace any loose screws with longer ones, and fill worn holes with wooden dowels or matchsticks and glue before re-screwing.
If the door still rubs, check the hinges. A thin shim behind a hinge can shift the door slightly and free the tight spot. Next, sand light marks with medium paper, then fine paper. Work gently along the grain and brush off dust.
When sanding is not enough, use a sharp plane. Take off only a little at a time, and always plane towards the centre of the edge to avoid splintering. Check the fit often. Remove the door from its hinges if you need to plane the bottom.
Finally, seal every bare timber edge with primer and paint. This keeps moisture out and stops the door swelling again. Then adjust the latch and strike plate until the door closes with a gentle click.
Special Cases: Fire Doors, External Doors and Older Doors
Some doors need extra care. Fire doors are designed with precise gaps, seals and fittings. Planing or cutting them can reduce their protection. Never change a fire door yourself. Ask a competent professional to inspect and repair it. The campaign Fire Door Safety Week offers useful guidance on why these doors matter.
External doors swell in rain and may shrink in dry weather. Seal all edges, including the top and bottom, and check weatherstripping. Security also matters, so make sure locks still line up after any adjustment.
Older London doors often have layers of paint, uneven frames and decorative detail. Handle them gently. If the door is part of a listed building or a period feature, ask a specialist before removing timber.
When to Call a Joiner
Some problems go beyond a simple fix. Call a professional joiner if you notice any of these signs:
- The door is badly warped, twisted or split
- The frame is damaged, rotten or has moved out of square
- Cracks above the door suggest structural movement
- The door is a fire door or a front door with security fittings
- You have tried basic fixes and the problem keeps coming back
- Planing would remove too much timber or spoil the design
A professional can adjust or rehang the door, repair the frame and fit new hinges or locks. If you search for a trusted door repair near me, choose a joiner with experience in your type of door. Trade bodies such as the British Woodworking Federation can help you understand good standards in joinery. A proper repair also protects your home and saves money on replacements.
How to Prevent Doors from Sticking Again
Prevention is easier than repair. These habits help:
- Seal all door edges, including the top and bottom, when painting
- Ventilate bathrooms and kitchens to control humidity
- Check hinge screws once or twice a year and tighten them
- Avoid heavy paint build-up by stripping old layers when needed
- Fix leaks and damp quickly, because wet walls swell frames
- Keep hinges and latches clean and lightly lubricated
The government’s guidance on damp and mould explains how to tackle the source of moisture, which protects your doors and your home.
Why Choose Housing Solutions For You?
Housing Solutions For You offers skilled carpentry and joinery for door repairs, adjustments and installations. Our team can fix sticking doors, rehang them and repair damaged frames, so every door opens and closes smoothly. We also provide window and door replacement when a repair is no longer worthwhile. After the fix, our painting and decorating team can seal and finish the door neatly. If damp is the cause, our plumbing team can find and fix leaks. Landlords and homeowners get clear quotes, careful workmanship and one team for every job.
Final Thoughts
A sticking door is usually a simple problem with a simple answer. Find the rub point, tighten the hinges, ease the tight spot and seal the timber. If the door is warped, the frame has moved or it is a fire door, call a professional. Housing Solutions For You is ready to help you fix every door in your London home or rental. Act early and your doors will open and close smoothly for years.
“Call us today at +44 7984 122 111 and let’s chat, or visit us at London, UK.”






